Joined in 2023 
82 
63 About this deal
After unscrewing and removing the second and third slot cover, our ATX build slipped right into the H7 Flow with zero issues. Placing the radiator on the top panel while using its fans as exhaust provides voltage-regulator cooling benefits, though at some cost in CPU temperature. With the fans peaking at a speed of 1,200rpm, they’re not particularly powerful, so it wasn’t a surprise to see the H7 Flow return middling results with the CPU and GPU delta temperatures. However, the flip side is that it’s extremely quiet, even with the fans at full speed. The CPU delta T of 48°C was on par with the Antec NX700 and Corsair 5000D Airflow, while the Antec DF700 Flux, Fractal Design Meshify 2 and Cooler Master MasterBox 500 were a little cooler. However, the NZXT was a couple of degrees cooler than the Fractal Design Meshify 2 Compact. At the bottom of NZXT’s H7 lineup is the standard H7, a model that features a plain front panel design that will be familiar to most NZXT users. When compared to the higher-end H7 Elite model, the only major differences are the H7 Elite’s tempered glass front panel, the Elite’s inclusion of additional fans, and its inclusion of a fan/RGB controller.
Then, our testing of GPU thermals. The HAF 500 fed our GPU the coolest air, followed by the H7 Flow without the top exhaust filter fitted in place, and then the H7 Flow with top exhaust filter...The dust filter at the bottom of the intake duct wouldn’t make much sense if the face panel didn’t also have a filter, so NZXT equips the H7 Flow’s snap-off front with a snap-in plastic-framed filter that covers the entire ventilated section. When letting each case run with their maximum out of the box fan RPMs, the H7 and H7 Elite deliver identical thermal results, proving that the Elite’s additional fan do nothing to lower overall system temperatures. This is a poor showing for the H7 Elite, and highlights the real strength of the H7 Flow. It bests the Elite with fewer fans and a lower price point. Even with an AMD Ryzen 9 5950X processor, you'll see a good 5% reduction for average temperature in games. It's still not quite as good as some other PC cases, namely the be quiet! Silent Base 802 or NZXT H7 Flow, but it's good to see lower temperatures all in keeping the same overall look of the existing H710.
There is a ton of information in these charts and the obvious takeaway is that the Flow front panel works best when combined with the 140mm fans running at high speeds. That will come as no surprise but when you refer to our video you will hear the huge changes in noise levels and there are times when the H7 can be very noisy indeed. In other words, the H7 can work well however you will need to strike a balance between noise and cooling. Closing Thoughts The NZXT H7 is in quite the predicament. The H7 Flow is by far the better PC case. It has better thermals, is the same price, has all the same features and has a completely clean side panel thanks to the large intake vent upfront. If you want something a little fancier, the NZXT H7 Elite has more tempered glass than you'll know what to do with. As we demonstrate in our video the three models of NZXT H7 are based on the same core chassis and they are defined by the front panel and the configuration of the fans. The showstopper is the H7 Elite which has three RGB fans at the front of the case that provide an impressive lightshow. Cooling Performance The H7 flow offered the best CPU temperature thanks to its open front end, but was only a degree ahead of the H7 Elite, which had three front fans to aid cooling despite its front section being closed.Sadly, when looking at the H7 and H7 Elite, thermal results were less impressive, especially with regards to the Elite. Even with its additional fans, the H7 Elite does not run much cooler than NZXT’s standard H7, with both cases exhibiting GPU thermals that are 5 degrees hotter than the H7 Flow. If you want low system thermals, the H7 Flow is clearly the case you should be buying. I've gone into some detail about the NZXT H7 series refresh in my NZXT H7 Flow review, but the goal NZXT's designers had in mind was to keep the same look but refine the cooling performance. This was carried out by adding a new side vent for the front fans to gain access to more cool air, as well as a redesigned top panel. A one-piece front-panel button/LED connector, HD Audio, USB 3.x Gen 2 (for the Type-C port), and USB 3.x Gen 1 (for the Type A ports) complete the front-panel cable selection. With the front panel being perforated, the H7 Flow’s right side panel can be completely closed off. Unlike the H7 and H7 Elite, the H7 Flow does not require a perforated right side panel for airflow, allowing NZXT to ship this model with a plain right side panel. What stopped them from launching meshed versions alongside the older cases? For a comparison, Fractal has their Define and Meshify(recent Pop Air too) series.
Great Deal 
New Comment