Corsair Commander PRO Digital Fan And RGB Lighting Controller - Black

Product Information

For example, if you want a quiet system and your system temperature runs within acceptable limits, you can have the Commander PRO turn off all your system fans with a custom fan curve.

Any electric motor has a much higher starting draw than at constant speed. A single .3 amp fan might draw .5 amp for a half a second on start. A .9 amp fan might draw 1.2 amps on start. Three .3 amp fans together might draw 1.5 amps and that may be past the tipping point. Also, amperage is dependent on wire size. If the wire is small and the draw high, it can cause voltage drop, also a potential problem. Commander Core and Commander Core XT have the RGB hub on the inside, but can therefore only do 6 fans. PWM (only) control for 6 fans is on the other side. People who have an Elite cooler have a regular Commander Core. If you are buying, get the XT. You should not be plugging the internal powered USB hub to the USB Passthroughs on the Commander Pro fan controllers. If you are going to utilize an internal powered USB hub then it should be connected directly to the motherboard header, and then the other devices plugged in to the powered USB hub. D) Channel 1 is occupied by 6 LL series fans (2x 140, 4x 120. don't see any brightness controls, so i'll assume 100%. Plans were to swap my 4x RGB led strips out with 1 the strips of 1 kit. No more

The Commander Pro has a USB connector and a SATA power connector. You can connect the Commander Pro in one of the USB header on the motherboard, usually located at the bottom portion of the motherboard. The Commander Pro has two USB 2.0 headers, this means you can connect another accessory, like the Lighting Node Pro, via the Commander Pro instead of connecting it directly to the motherboard. This minimizes the exposed cables, giving a nice and clean build with well-managed cable routing. In addition to all the onboard devices you can plug directly into the Commander PRO, there’s also an integrated USB 2.0 HUB so you can plug in other USB devices that would otherwise take up a USB header on your motherboard. This is especially handy if you want to have one of our intelligent power supplies or Hydro Series liquid cooler plugged into a single USB header.

Create, customize, and synchronize stunning RGB lighting effects when you connect CORSAIR RGB fans and lighting strips for an amazing system-wide light-show. Powered by CORSAIR iCUE software, the CORSAIR Commander PRO is everything you need to turn your case into a smart case. Connect, Command, Control Third - your coolant temperature is 38C. That's very high for idle (in most cases). If you want us to examine your cooling issues further, you're going to need to provide a LOT more information. For example -The 6 fans on the front and side are connected to the PWM Repeater that is with the 5000D Airflow and atm they are connected to the MB (Strix Z590-3 with an i9 11900k) and using the bios to control the intake, they are also connected to their own RGB hub and Lighting Node.

I'm not seeing any "special cable" in the kit though. Only a power adapter, 4 rgb extension cables and a micro usb to usb a cable (which i assume lets it talk to iCue for lighting, while the adapter supplies power. Powerful CORSAIR iCUE software brings everything together, allowing you to customize RGB lighting, monitor hardware and coolant temperatures, and adjust fan and pump speeds, all from a single intuitive interface. Low profile and easy to installI've received the transistors (MMSS8550 650mW) and replace all of them in CP (6 in total). See picture: